Sprinkler System Installation in Kodak & Across East Tennessee
A new sprinkler system should fit your yard, not the other way around. Chris plans the layout from the ground up — zoning by sun and shade, spacing heads for even coverage, trenching clean, and programming the controller — then walks you through the whole thing when it is done. You deal directly with the person doing the work from the first walk-through to the final head test.
Thinking about a new system? Talk it through with Chris first.
Call or Text (865) 806-4619Why a properly planned install matters
From walk-through to the final head test
Planning the layout
Chris walks your property first. He notes the sunny slopes, the shaded beds, the steep grade changes, and where your water source and pressure sit. From there he sketches a zone-by-zone layout so each section of your yard gets the right amount of water instead of a one-size-fits-all blanket.
Zoning by sun, shade, and plant type
A sunny hillside dries out fast while a shaded flower bed stays damp for hours. Mixing the two in one zone guarantees one is overwatered and the other goes thirsty. Chris groups heads into zones by sun exposure and plant type so each zone runs only as long as it needs to.
Head-to-head coverage
Every sprinkler is spaced so its spray reaches the next head. That overlap is what gives you even green across the lawn instead of dark stripes and dry streaks between heads. Chris sets the spacing and nozzles to match your actual water pressure, not a textbook number.
Trenching
Pipe gets trenched below the sod line so it doesn't surface with freeze-thaw cycles or aerating. Chris backfills carefully and rakes the turf back into place so the lawn settles in cleanly rather than looking like a construction site.
Controller setup
Chris wires the controller, assigns each zone its start time, and sets the run lengths to match the soil. A spring cycle looks different from a July cycle, and the programming reflects that.
Walking you through the system
Before Chris leaves, he walks you through every zone, shows you where the shut-off and backflow sit, and demonstrates how to adjust the controller. You are never handed a manual and left to figure it out — the person who built the system explains it to you.
East Tennessee yards are rarely flat and never simple. A sunny hillside above Kodak behaves nothing like a shaded bottomland bed in Seymour, and the sprinkler layout has to respect that. Chris sizes nozzles and zones to your real water pressure so you never end up with misting heads that can barely reach the next row. The whole point of planning the layout first is that the system runs the way it should from day one instead of needing months of tweaking.
Trenching is the part homeowners worry about most, and rightly so — a careless install tears up a lawn. Chris trenches below the sod line, lays the pipe, and puts the turf back so it settles in without leaving a visible scar across the yard. The controller gets wired and programmed for your zones, and the seasonal start times are set to match how long the soil actually holds water here. If you want to go deeper into how a system is zoned for slope and clay, see the irrigation design page.
Common questions about installing a sprinkler system
How do you plan a sprinkler system layout for my yard?
Chris walks the property, notes sun and shade zones, slope, plant types, and your available water pressure, then groups heads into zones so each area gets even head-to-head coverage without overwatering.
Why do you zone sprinklers by sun and shade?
Sunny slopes dry out faster than shaded beds, so mixing them in one zone leaves the shady spots soggy. Grouping similar sun exposure lets each zone run the right amount of time for its conditions.
What is head-to-head coverage and why does it matter?
Head-to-head coverage means each sprinkler's spray reaches the next head, so water overlaps evenly across the lawn. Without it you get dry streaks and brown patches between heads.
How deep do you trench for sprinkler lines?
Chris trenches the pipe deep enough to stay below the sod line so it doesn't surface with freeze-thaw cycles or aeration, then carefully backfills and rakes the turf back into place.
Do you set up the controller and show me how to use it?
Yes. Chris wires the controller, programs the start times for each zone, and walks you through the whole system before he leaves so you know how to adjust it seasonally.
Do you install sprinkler systems in Kodak and Sevierville?
Yes. A Drip Sprinklers is based in Kodak and installs irrigation systems across Sevier, Knox, Jefferson, Blount, and Hamblen counties. Call or text (865) 806-4619 to schedule a walk-through.
Where Chris installs sprinkler systems
Based in Kodak, TN, Chris installs irrigation systems across Sevier, Knox, Jefferson, Blount and Hamblen counties. Pan and zoom to find your area.
Tell Chris What's Going On
Tell Chris about your yard or system and he will follow up with you directly.